Rohs (Restriction Of Hazardous Substances); Manufacturer's Warranty - Hilti TE 500 Manual

Trouble or fault
The power tool doesn't start
and the service indicator
lights red.
The tool does not achieve full
power.
The chisel cannot be released
from the chuck.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10

RoHS (Restriction of Hazardous Substances)

TE 500
The following links take you to the table of dangerous substances: qr.hilti.com/r3661 (TE 500) and
qr.hilti.com/r3662 (TE 500-AVR).
You will find a link to the RoHS table, in the form of a QR code, at the end of this document.
11

Manufacturer's warranty

▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Printed: 15.05.2018 | Doc-Nr: PUB / 5142390 / 000 / 04
Possible cause
The tool is faulty or servicing is
due.
The gauge (cross section) of the
extension cord conductors is inad-
equate.
The control switch is not fully
pressed.
The chuck is not pulled back fully.
Action to be taken
▶ Have the product repaired only
by Hilti Service.
▶ Use an extension cord with
an adequate conductor cross
section.
▶ Press the control switch as far
as it will go.
▶ Pull the chuck back as far as
it will go and remove the insert
tool.
English 11