Troubleshooting; Rohs (Restriction Of Hazardous Substances) - Hilti TE 3000-AVR Manual

• Store tools and appliances in a dry place where they cannot be accessed by children or unauthorized
persons.
• Check electric tools or appliances for damage after long periods of transport or storage.
8

Troubleshooting

If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 Troubleshooting
Trouble or fault
The breaker doesn't start.
The service indicator lights
red.
The service indicator blinks
red.
No hammering action.
The breaker doesn't start or
cuts out during operation.
9 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
10

RoHS (Restriction of Hazardous Substances)

Click on the link to go to the table of hazardous substances: qr.hilti.com/r4783.
There is a link to the RoHS table, in the form of a QR code, at the end of this document.
*2190683*
Printed: 05.02.2019 | Doc-Nr: PUB / 5363993 / 000 / 01
Possible cause
Electronics initialization in progress
(takes up to 4 seconds after plug-
ging in). The electronic restart in-
terlock is activated after an inter-
ruption in the electric supply.
Interruption in the electric supply.
The generator is in sleep mode.
The detachable supply cord is not
fitted correctly.
The tool is faulty or servicing is
due.
The voltage provided by the elec-
tric supply is too high.
The overheating prevention cut-out
has been activated.
The power tool is too cold.
The extension cord is too long or
its gauge is inadequate.
2190683
Action to be taken
▶ Switch the power tool off and
then on again.
▶ Plug in another electric tool or
appliance and check whether it
works.
▶ Apply a load to the generator
by connecting a second power
consumer (e.g. worklight).
Switch the tool off and then on
again.
▶ Fit the detachable supply cord
to the power tool correctly.
▶ Have the product repaired only
by Hilti Service.
▶ Use a different power outlet.
Check the electric supply.
▶ Allow the tool to cool down.
Clean the air vents. Running
under no load is still possible.
▶ Bring the tip of the accessory
tool into contact with the
working surface, switch the
power tool on and allow it to
run. If necessary, repeat the
procedure until the hammering
mechanism begins to operate.
▶ Use an extension cord of an
approved length and / or of
adequate gauge.
English 21