Installation; Names Of Parts; Installing The Scale Unit - Magnescale SmartSCALE SQ57-Z Series Manual

3. Installation

For the installation dimensions, refer to section 7, "Dimensional Diagrams."

3-1. Names of Parts

Scale unit
End cover
Scale set
Terminal A

3-2. Installing the Scale Unit

Notes
• Do not turn on the power before installing the scale and the sensor head.
• Only use combinations of scales and sensor heads that are shipped together.
• Th e sensor head will be damaged if the sensor head is moved outside the eff ective length (L) aft er
installation. Th e sensor head must always be moved within the eff ective length.
• Install the scale unit so that the scale is on the upper side of the sensor head.
If the upper side is not available, set it to face horizontally. (Fig. 3-1)
• Install the scale cover last aft er installing the sensor head.
• Use a scale installation bracket, where applicable, having length covering the entire scale length. Th e use
of a divided bracket may impair the scale accuracy.
Before installationn
• Check that the alignment of the installation surface (or installation brackets) is within the standards.
(Standard: Refer to section 7, "Dimensional Diagrams.")
• Th e scale is grounded by installation surface contact, so do not coat the installation surface.
6
(E)
Mounting hole M6 Scale cover
Water-proof cap
Sensor head
Mounting hole M6 or M8
CH22
Connection cable
Scale
Scale
Sensor
head
(○) (△)
Fig. 3-1
Scale cover mounting hole M4
Terminal B
Sensor Sensor
head head
Scale
(×)
Scale
End cover
SQ57
SQ57-Z Series, CH22 Series