Indicator Charge Level; Used Batteries; Operating; Removing / Inserting The Battery - Grizzly AKS 4035 Lion Original Instructions For Use

LED-lights:
• The LED-control light of the battery
charger (20)
- lights up permanently red during
the charging process
- lights up permanently green,
when charging process is complete
- lights up permanently green and
red, when the overheating protec-
tion of the charger is active.
- flashes green and red when there
is an error (e.g. faulty battery).

Indicator charge level

A B
max. 40-V-Lithium-Ion
K L
Press the „Press" button on the right of
U V
charging level indicator ( A B C
to check the status of the battery.
K L M
The number of illuminated LED lights
U V W
shows the charge level of the battery.

Used batteries

A B C
• If a fully recharged battery lasts for
considerably shorter operating times,
K L M
the battery (
needs to be replaced. Only use an
OEM battery pack replacement avail-
U V W
able from our Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Cleaning and Main-
tenance").
C D
M N
W X
D E 19b), in order F G H
N O P Q R
X Y Z
D E
N O
19) is used up and
X Y

Operating

Switch on the chainsaw only when
chain bar, saw chain and sprocket
chain wheel covering are correctly
assembled.
Make sure you have a secure
stance. Before starting, ensure that
the electric chainsaw is in contact
with no objects.
Caution! Saw can oil up, see notes
on Operation startup.

Removing / inserting the battery

E F G
1. To remove the battery (19) from
the appliance, press the release
button (19a) on the battery and
O P Q
pull out the battery.
2. To insert the battery (19), place it
Y Z
I J on the guide track (17) and push
it back into the appliance. It will
S T
audibly snap in.

Switching on

1. Check before the start, whether
F G H
sufficient chain oil is in the tank
and, if necessary, refill with chain
P Q R
oil (see Chapter Operation Start).
2. Release the chain brake, where
you shift the brake arm (3) back
Z
against the front grip (8).
3. Hold the chainsaw firmly with
both hands, with the right hand
on the rear grip (1) and the left
hand on the front handle (8).
Thumb and finger must close se-
curely over the handles.
4. For switching on, activate the
switch-on block (11) with the right
thumb and then press the On/Off
switch (10), the chainsaw runs
with highest speed. Release the
H I J
R S T
I J
S T
GB
101