Bolt The Load Cell To The Base Plate; Figure 5-4 Bolt The Load Cell To The Base Plate - Siemens SIWAREX WL230 Operating Instructions Manual

Installation
5.2 Installing the base plate and elastomeric bearing
5.2.6

Bolt the load cell to the base plate

Procedure
Figure 5-4
1. Place the load cell on the base plate in alignment with the drill holes.
2. Position the washers.
3. Screw in and tighten the hexagon bolts.
28
Bolt the load cell to the base plate
NOTICE
Damage to the load cell
When tightening the bolts, do not hold the load cell to counter the force. This will prevent
damage to the load cell.
Adhere to the tightening torques:
• SIWAREX WL230 SB-S SA load cell with a rated load of 0.5 t, 1 t, 2 t: 80 Nm
• SIWAREX WL230 SB-S SA load cell with a rated load of 5 t: 391 Nm
Operating Instructions, 03/2013, A5E31529044A-01
SB-S SA