Floor Mount Adapter, 223952; Can Cables; Light Tower Kit, 255468; I/O Cable, 122029 - Graco E-Flo SP Installation And Parts Manual

Kits and Accessories
2. Ensure the wall mount is level using the wall bracket
as a template. Drill four 7/16 in (11 mm) diameter
holes for the mounting bolts. See Figure 27 for the
mounting hole fastener locations.
3. Bolt the bracket securely to the wall.
Mounting Hole
F . 27: Wall Mount Hole Locations
IG
4. Use the screws and washers supplied with the wall
mount and refer to the Electric Driver Mounting
Hole Pattern on page 35 to mount the driver to the
bracket once it is secured to the wall.

Floor Mount Adapter, 223952

806
802
F . 28: Floor Mount Stand
IG
Ref Part Description
801 186562 PLATE, mounting inductor
802 186560 TUBE, adapter
803 186561 COUPLING, pipe
804 166538 PLATE, base
806 185542 COUPLING, half
32
Locations
801
803
Refer to the Floor Stand Mounting Hole Diagram on
page 35 and the Floor Stand Accessory manual for
proper installation of this floor mount adapter. See
Related Manuals on page 2.

CAN Cables

The following CAN cables and splitter are available for
use with E-Flow SP electric pumps.
Part Description
125306 CABLE, CAN, female/female
123422 CABLE, CAN, female/female
121000 CABLE, CAN, female/female
121227 CABLE, CAN, female/female
121001 CABLE, CAN, female/female
121002 CABLE, CAN, female/female
121003 CABLE, CAN, female/female
120952 CABLE, CAN, female/female
121201 CABLE, CAN, female/female
121004 CABLE, CAN, female/female
121228 CABLE, CAN, female/female
123341 CABLE, CAN, female/female
121807 CONNECTOR, splitter, male/male

Light Tower Kit, 255468

For D200s, D200, and D60 single supply systems.
See the Light Tower Kit manual for more information.

I/O Cable, 122029

See the E-Flo SP Software Instructions manual for
setup and pin out information.
Part Description
122029 CABLE, GCA, M12-8p
804
Qty
1
1
1
1
1
Length
0.3 m
0.5 m
0.5 m
0.6 m
1.0 m
1.5 m
3.0 m
4.0 m
6.0 m
8.0 m
15.0 m
40.0 m
Length
15.0 m
3A6586D