Inlet Pressure Sensor Kit, 24Y245 - Graco E-Flo SP Installation And Parts Manual

Kits and Accessories
9. Connect the CAN cable included in the kit to either
port 1 or port 2 (whichever is available) on the
driver. See Figure 23.
Port 1
F . 23: Driver Port Locations
IG
10. Connect the other end of the CAN cable to either
CAN port 1 or 2 on the CGM. See Figure 20. It can
be connected to either port.
NOTE: Longer CAN cables, if required, are available
from Graco. See CAN cables on page 32.
11. Connect the Ethernet, DeviceNet, or PROFIBUS
cable to the fieldbus connection on the CGM as
applicable. See Figure 24.
F . 24: CGM Fieldbus Connection
IG
30
Port 2
Port 6
Fieldbus
Connection
12. Connect the other end of the cable to the fieldbus
device.
13. Refer to the Graco Control Architecture Module Pro-
gramming manual for step-by-step instructions on
how to update the software version of GCA mod-
ules. See Related Manuals on page 2.
14. Refer to the E-Flo SP Software Instructions manual
for details regarding the fieldbus pinout setup and to
perform the setup procedure to configure the field-
bus. See Related Manuals on page 2.
Inlet Pressure Sensor Kit,
24Y245
Part Description
16U440 ADAPTER, fitting, pressure sensor
15M669 SENSOR, pressure, fluid outlet
119348 PACKING, o-ring
Attach the 5-pin connector to port 6 on the driver. Insert
the o-ring over the other end and connect the adapter
fitting. Attach the assembled pressure sensor to the fluid
input stream based on the configuration of your system.
Qty
1
1
1
3A6586D