Operation - HAMPTON BAY HB-7902-02 Use And Care Manual

Installation (continued)
6
Mounting the doorbell extender
Use either the screws (BB) or double-sided tape (DD)
to mount the doorbell extender (B).
To mount with screws (AA), temporarily
remove the batteries and place the doorbell
extender (B) against the mounting surface and
mark the two screw holes.
Drill two 7/32 in. pilot holes and insert wall
anchors (CC). Align the holes in the doorbell
extender (B) with the wall anchors (CC) and
insert two screws (BB). Tighten securely and
replace the batteries and cover.
When attaching the doorbell extender (B) with
double-sided tape (DD), remove the paper from
both sides of the double-sided tape (DD) and
apply to a clean surface. Install the cover.

Operation

1
Adjusting the doorbell volume
The doorbell (A) has an adjustable volume control
located on the side. Rotate the thumbwheel up or
down to adjust the volume.
2
Setting the doorbell extender
The wireless doorbell extender (B) has two options
for tune selection: Play the selected "FRONT" door
musical tune or play the "REAR" door designated tune
(Ding).
Remove the single jumper (AA) inside the
doorbell extender (B) to play the selected
musical tune.
Add the single jumper (AA) inside the doorbell
extender (B) to play only the Ding tune.
BB
Remove jumper to
set as the "FRONT" door
6
B
A
B
Add jumper to set
as the "REAR" door
DD