Table of Contents
Advertisement
Level 0
(MISC SETTINGS)
(RESET
COUNTERS)
(SELECT PROFILE)
(DATE AND TIME)
(ACTUATOR TEST)
* Note: Certain parameters can only be changed by the dealer while others can only be changed by the
manufacturer (designated by an *). Some default parameters are subject to change during firmware updates
per the manufacturer. The dealer password is available on the Briggs and Stratton
4
Operating Modes
There are two modes of operation:
Auto Mode
Manual Mode
4.1
Auto Mode
To enter Auto Mode, push the "AUTO" key. While in Auto Mode, the generator will start and run under
any one of these conditions:
Auto Mains Failure (AMF)
Remote Start/Stop (2 Wire)
Auto Exercise
4.1.1
Auto Mains Failure (AMF)
When the Mains Monitoring is enabled (default setting) in the Mains configuration and the controller is
in the Auto Mode, AMF mode gets activated.
In this mode, if the Mains is healthy, the genset remains in the OFF condition. When the Mains voltage
drops below a certain threshold, the controller gives a start command. Once the genset is started and
its loading parameters reach the threshold values, the genset contactor is latched and the load is
Level 1 (On screen)
(GAIN SCHEDULE TRIGGER)
Start/Stop
Configuration
(STR/STP DEV
CNFG)
PASSWORD 1
PASSWORD 2
PASSWORD 3
(GENSET)
(SELECT PROFILE)
(DATE)
(TIME)
(ACTUATOR TEST)
Level 2 (On screen)
(INTEGRAL GAIN)
* Derivative Gain (Kd)
(DERIVATIVE GAIN)
* Friction Setoff
(FRICTION SETOFF)
* Gain Schedule Trigger
* Loading Factor
(LOADING FACTOR)
* Unloading Factor
(UNLOADING FACTOR)
* Running Steps
(RUNNING STEPS)
* ####
####
####
* (RUN TIME)
(NO. OF STARTS)
(NO. OF TRIPS)
(Profile Name)
(DD / MM / YYYY)
(Hours)
(ENABLE)
(TEST DURATION)
Parameters (On screen)
0 – 1000
0 – 1000
0.0 – 100.0 %
0 – 1000
0 – 1000
0 – 500
0 – 9 for each digit
0 – 9 for each digit
0 – 9 for each digit
(In hours)
(In numbers)
(In numbers)
A – Z, 0 – 9
0 – 9 for each digit
(In hours)
Yes/No
0
– 10 sec
®
Power Portal.
Page | 14
Hide quick links:
Advertisement
Table of Contents
