Briggs & Stratton GC1031 Operation Instructions Manual page 17

Level 0 Level 1 (On screen)
Configuration
(MAINS CONFIG)
Under-voltage
Monitoring
(UNDER VOLT
MON)
Mains
(MAINS)
Over-voltage
Monitoring
(OVER VOLT MON)
Under-frequency
Monitoring
(UNDER FREQ
MON)
Over-frequency
Monitoring
(OVER FREQ MON)
Engine Crank Disconnect
(ENGINE) (CRANK DISCON)
Level 2 (On screen)
* Over-load Monitoring Delay
(OVERLOAD MON DELAY)
* Unbalanced Load Action
(UNBAL LOAD ACTION)
* Unbalanced Load Threshold
(UNBAL LOAD THRESHOLD)
* Unbalanced Load Delay
(UNBAL LOAD DELAY)
* Extended Over-load Trip
(EXT OL TRIP)
* Extended Over-load Trip
Threshold
(EXT OL THRESHOLD)
Mains Monitoring
(MAINS MONITORING)
* Mains AC system
(MAINS AC SYSTEM)
* Phase Reversal Detection
(PHASE REVERSE DETECT)
* Phase Reversal Action
(PHASE REVERSE ACTION)
* Under-voltage
(ENABLE)
* Trip
(TRIP)
* Return
(RETURN)
* Over-voltage
(ENABLE)
* Trip
(TRIP)
* Return
(RETURN)
* Under-frequency
(ENABLE)
* Trip
(TRIP)
* Return
(RETURN)
* Over-frequency
(ENABLE)
* Trip
(TRIP)
* Return
(RETURN)
* Start Attempts
(START ATTEMPTS)
* Disconnect On Oil Pressure
Parameters (On screen)
1 – 600 sec
None/Notification/Warning/
Electrical Trip/Shutdown
5 – 200 %
1 – 600 sec
Disable/Enable
50 – 150 %
Disable/Enable
Single Phase 2 Wire/Single
Phase 3 Wire/Three Phase 4
Wire (1Ph 2 wire/1Ph 3 wire
/3Ph 4 wire)
Disable/Enable
None/Notification/Warning/
Electrical Trip/Shutdown
Disable/Enable
50 – 298 Volt Ph-N
52 – 300 Volt Ph-N
Disable/Enable
102 – 350 Volt Ph-N
100 – 348 Volt Ph-N
Disable/Enable
10.0 – 59.0 Hz
11.0 – 60.0 Hz
Disable/Enable
26.0 – 75.0 Hz
25.0 – 74.0 Hz
1 – 9
Disable/Enable
Page | 11