Configuration Of Gcu; List Of Parameters; Figure 3: Configuration Mode Screen; Figure 4: Configuration Mode Authentication Page Screen - Briggs & Stratton GC1031 Operation Instructions Manual

3

Configuration of GCU

To configure the controller, please do the instructions that follow:

To enter the configuration mode, push and hold the "STOP" key for at least 3 seconds. The
following screen will appear on the GCU:

If you want to only view the configuration, push the "STOP" key on the GCU. If you wish to
change the configuration, push the "START" key on the GCU.

Figure 4: Configuration mode authentication page screen


The GCU will ask for a password (0000). Enter the password by using the up & down arrow key
for changing the digit and the "START" key for selecting the digit. The 4 digits will start blinking
individually as each one is selected. Press the "START" button as mentioned earlier to enter the
correct digit.

After completion of the parameter configuration, push and hold the "STOP" key to exit from
configuration mode. Before exiting from the configuration mode the controller will show the
following screen:
3.1

List of Parameters

The table that follows gives a brief overview of configurable parameters in GC1031 controller.

Table 4: Parameters

Level 0
Module
(MODULE)

Figure 3: Configuration mode screen

Figure 5: Saving settings screen

Level 1 (On screen)
General
(GENERAL)
Level 2 (On screen)
* Power On Mode
(POWER ON MODE)
* Power On Lamp Test
(POWER ON LAMP TEST)
Load Histogram
(LOAD HISTOGRAM)
Auto-Clear Warning Alarm
(WARNING AUTO CLEAR)
Language
(LANGUAGE)
Parameters (On screen)
Manual/Auto
Disable/Enable
Disable/Enable
Disable/Enable
English
Page | 5