Spare Parts; Warranty Provision; Customer Service; Safety - GCE druva MPLH0XS0 Instructions For Use Manual

1.6. SPARE PARTS

WARNING!
•
Risk of injury from using incorrect spare parts!
•
The use of incorrect or defective spare parts can result in risks for the operating sta and in damages,
EN
malfunctions or total failure of the system.
•
Only use original spare parts from the manufacturer or spare parts authorized by the manufacturer.
•
Always consult the manufacturer if in doubt.
LOSS OF WARRANTY
•
The manufacturer's warranty lapses if unauthorized spare parts are used.

1.7. WARRANTY PROVISION

The warranty provisions are included in the manufacturer's general terms and conditions of business. See
chapter VI. Warranty Claims.

1.8. CUSTOMER SERVICE

GCE GmbH
Weyherser Weg 8
DE-36043 Fulda
+49 (0) 661 8393 -0
www.gcegroup.com
service.druva@gcegroup.com
Please do not hesitate to provide us with information and experiences gained through use; we welcome any
valuable input that will help to improve our products.

2. SAFETY

This section provides an overview of all the important safety aspects to ensure the protection of your sta
and the safe and trouble-free operation of the equipment. Further safety information relating to specifi c tasks
can be found in the sections on the individual life cycle phases.

2.1. INTENDED USE

The manifold is only usable for the defi ned standard gases and pressures observing the given temperature
range. The maximum fl ow is 20 m
Intended use also includes compliance with all the information in these instructions and compliance with
reparation, maintenance working, type label and data sheets.
Any use other than, or above and beyond, the intended use constitutes improper use.
WARNING!
•
Danger from improper use!
•
Improper use of the system can lead to dangerous situations.
•
Never use the manifold with liquid fl uids.

2.1.1. STRUCTURAL CHANGES AT THE MANIFOLD

Without written approval of supplier no extensions, additions or alternations are allowed on the manifold.
Components which are not in perfect condition have to be changed immediately.
Cleaning of manifold and disposal of residues
Used components which are ready for reparation has to be purged with an inert gas before.
Noise Generation
In some cases when specifi c infl uence quantities collaborate together, e.g. fl ow and pressure range can
cause noise generation or the gas itself. If this happens please contact supplier.
/h.
3
8/68