Switching On The Appliance; Switching On The Cooking Zones; Selecting The Cooking Zone Heat Setting - Hansa BHI68014 Instruction Manual

OPERATION
Control Panel
● Immediately after the appliance is connected to electrical mains, all displays will light up
briefly. Your induction hob is then ready for use.
● The induction hob is equipped with electronic touch control sensor fields, which are
operated by touching with a finger for at least 1 second.
● Touching of a sensor field is accompanied by an acoustic signal to acknowledge.
No objects should be placed on the sensor fields (this could cause an error).
Touch sensor fields should be always kept clean.

Switching on the appliance

To switch on the appliance touch and hold the on/off sensor field (4) for at least 1 second.
The appliance is switched on when all displays show „-" or „--".
1
3
If none of the sensor fields is touched within 60 seconds, the appliance switches
itself off.

Switching on the cooking zones

Once the appliance is switched on using the on/off sensor field (4), select a cooking zone (1)
within the next 60 seconds.
1. When a cooking zone selection sensor field (1) is touched, „5" on the corresponding heat
setting indicator display will become bright.
2. Set the desired heat setting using the „+" (2) or „-" (2) sensor fields.
If none of the sensor fields is touched within 60 seconds of switching on the
appliance, the cooking zone switches off.
A cooking zone is active when its display shows a digit or a letter. This indicates the
cooking zone is ready for the heat setting to be set or changed.

Selecting the cooking zone heat setting

When the cooking zone display (3) shows bright "0", start setting the desired heat setting
using the „+" (2) or „-" (2) sensor field.
2
5
38
1
4