Advertisement
Knifonium
Plugin Manual
1
2
Ext CV
Ext 1
1
Sets scaling of the external sidechain signal.
The fullscale sidechain signal (the digital range -1 to +1) will be scaled up to -10
to +10 volts.
Ext 2
2
Sets scaling of the external sidechain signal.
The fullscale sidechain signal (the digital range -1 to +1) will be scaled up to -10
to +10 volts.
Tip: Make sure you have the volume turned down on your monitors or
headphones for this example.
Load the Knifonium in its default state on an instrument track. Create another
track and add another synth modulating a Sine tone. Try the lowest octave
possible for this example (inaudible, please be careful with your volume here),
select the sidechain in on the Knifonium track and route the tracks.
Next, go to VCO 1 and switch the Ext 1 parameter to '+'. Increase the VCO 1 'Mod
Amount'1 to 10. Now slowly turn up Ext 1 under the Ext CV section.
Now you should start hearing the external input modulating the OSC. You can
also increase the second synth's frequency (in other words go up higher)
and see how this changes the character of the Knifonium to FM like sounds.
You can then start combining Ext 2 and route it to OSC 2 or VCF with LFO etc.
The key is to experiment and try different sound sources for your input as well.
9
Advertisement
