Advertisement
Knifonium
Plugin Manual
1
2
3 4
VCF
Frequency
1
Sets the VCF's cutoff frequency. The output filter is a low pass 4th order
ladder filter.
Keyboard Tracking
2
Determines how much the cutoff frequency is varied by the keyboard's CV.
Resonance
3
Sets the VCF's resonance.
The filter will self-oscillate with higher resonance settings.
M/S
4
Turning the M/S knob all the way to the left sends the mid signal (M) completely
through the filter, while the side signal (S) bypasses the filter completely.
Turning the knob clockwise from this position gradually sends more side signal
through the filter and bypasses less.
In the 12 o'clock position the entire M and S signals pass through the filter as
they would with a regular (non-M/S) VCF. This is the default setting.
Moving clockwise from the 12 o'clock position will gradually send less mid
signal through the filter and more mid signal will bypass the filter.
When dialled all the way to the right, the mid signal will completely bypass the
filter, while the side signal passes through it 100%.
Tip: To get the full effect of the side signal you should adjust the 'spread'
parameters under each oscillator.
13
Advertisement
