Husqvarna TC 250 2012 Specifications - Operation - Maintenance page 72

LUBRICATING THE CHAIN
Lubricate the chain following these instructions.
WARNING * : Never use grease to lubricate
the chain. Grease helps to accumulate dust
and mud, which act as abrasive and hepl to
rapidly wear out the chain, the sprocket, and
the crown.
Disassembling and cleaning
When particularly dirty, remove and clean the chain before
lubrication.
Work as follows:
1 - Set a stand or a block under the engine and see that the rear
wheel is lifted from the ground.
Remove: screws (1), transmission sprocket guard (2), clip
(3), master link (4) and transmission chain (5);
To reassemble, reverse the above procedure.
1
1
EN - 30 SPECIFICATIONS - OPERATION - MAINTENANCE
2
5
4
3