Installing The Cooker Hood; Installation Requirements - Zanussi ZHC 916X Instruction Booklet

Please ensure that when the appliance is installed it
is easily accessible to an engineer in the event of a
breakdown.
All installations must comply with the
local authorities requirements for the
discharge of exhaust air.
Incorrect installation may affect the
safety of this cooker hood.

Installation Requirements

Before installation check the wall to
which the cooker hood is to be fitted for
electric cables, water pipes or gas.
The cooker hood is designed to be fixed to a solid block
or brick wall over a cooking area. If not, suitable fixings
must be used for other types of walls. The hood can be
used in the extraction (ducted to the outside) or
recirculation (internal recycling) mode.
The Installation work must be undertaken by a qualified
and competent person. The manufacturer disclaims any
responsibility to damages due to incorrect installation of
the cooker hood or if the cooker hood is not installed in
compliance with relevant regulations controlling this type
of installation.
Unpacking
Before unpacking the cooker hood position the carton
with the arrows pointing upwards as illustrated on the
carton.
The ZHC916 is supplied with the following
components for installation:
1 No. Canopy including controls and worktop illumination (C).
1 No. Telescopic chimney stack complete with fan motor (A).
1 No. Flange 120mm (F).
1 No. Collar 120-125mm (D)
1 No. Venting grille (G).
1 No. Spigot (R).
1 No. Ducting conversion bend (W)
1 No. Support Rod (B)

INSTALLING THE COOKER HOOD

11