Assembling The Blender Jug - Gastroback Design Mixer Advanced Plus Operating Instructions Manual

6. Remove the silicon seal from the blade assembly housing for cleaning. Grip the low-
er half of the blade holder around the outer wall and press downwards in a sharp
movement. the two parts will separate with a click.
7. Clean the parts with a soft sponge in warm soapy water and dry them off after-
wards. Pay attention not cutting yourself handling the blade. Do not use abrasive
cleaners, cleaning pads, corrosive chemicals (disinfectants, bleach) or any sharp or
hard objects (i.e. metal scouring pads) for cleaning, for this could damage the sur-
faces. Always handle the entire appliance with care and without violence.

ASSEMBLING THE BLENDER JUG

Ensure that the blender jug and all parts are clean before you assemble the appliance
and the lower part of the blade holder is clipped into place.
1. To reassemble the blender jug, replace the silicon seal onto the blade assembly hou-
sing. Ensure the sealing ring is in proper position. The sealing ring has to be clean
and show no crustifications, crinkles, cracks or look porous. You should be able to
read THIS WAY UP on the gasket.
2. Hold on to the blade assembly housing with your right hand and with your left hand
hold on to the handle of the blender jug. Upturn the blender jug and insert the blade
assembly housing into the jug base. Twist the Blade Removal System anticlockwise
until firmly locked into position.
58
ATTENTION: The circular plastic surround
attached to the base of the blender jug is not
removable.
ATTENTION: The circular plastic surround
attached to the blades is not removable.
WARNING: The blades are very sharp.
Pay attention handling it and if possible only
hold on to the blade assembly housing.
WARNING:
sharp. Pay attention handling it and if
possible only hold on to the blade
assembly housing.
The blades are very