Electrical Safety - Kernau KGH 4345 T CI B User Manual

CHAPTER 2. ELECTRICAL SAFETY
1. Plug the appliance in a grounded socket protected by a fuse conforming to the
values specified in the technical specifications chart.
2. Have an authorized electrician set grounding equipment. Our company shall not
be responsible for the damages that shall be incurred due to using the product
without grounding according to local regulations.
WARNING:
If the surface is cracked, turn off the appliance to avoid risk of electric shock.
3. Never wash the appliance by spraying or pouring water on it. There is a risk
of electrocution.
4. Do not touch the plug with wet hands. Do not pull the cord to plug off, always
hold the plug.
5. Unplug the unit during installation, maintenance, cleaning and repair.
6. Make sure the plug is inserted firmly into wall socket to avoid sparks.
7. If the power supply cord (the cord with plug) is damaged, this cord shall
be replaced by the manufacturer or its service agent or an equally qualified
personnel to prevent a hazardous situation.
8. Do not use cut or damaged cords or extension cords other than the original cord.
9. Do not use steam cleaners for cleaning the appliance, otherwise electric shock
may occur.
10. Make sure there is no liquid or humidity in the outlet where the product plug
is installed.
11. An omnipolar switch capable to disconnect power supply is required for installation.
Disconnection from power supply shall be provided with a switch or an integrated
fuse installed on fixed power supply according to building code.
12. The power supply cord (the cord with plug) shall not contact the hot parts of the
appliance.
13. Unplug the unit during installation, maintenance, cleaning and repair.
14. Appliance is equipped with a type ''Y'' cord cable.
15. The circuit breaker switches of the cooker shall be placed so that end user can
reach them when the cooker is installed.
16. Fixed connections shall be connected to a power supply enabling omnipolar
disconnection. For appliances with over voltage category below III, disconnection
device shall be connected to fixed power supply according to wiring code.
17. Do not remove ignition switches from the appliance. Otherwise, live electric
cables can be accessed. It may cause an electric shock.
EN
37