Table of Contents
Advertisement
Fault
Product does not
There is air in the heating installation.
start up:
– No hot water
After three successive failed ignition
– Heating does
attempts, the system switches to fault
not heat up
mode (fault code: F.28).
Hot water gener-
The external controller is not set cor-
ation functioning
rectly.
correctly; heating
does not start up.
0020239561_01 Easicom 3 Operating instructions
Cause
Appendix
Measure
Purging the radiators
If the problem occurs again: In-
form the competent person
Press the
button. The product
carries out a new ignition attempt.
If the ignition problem is not rec-
tified after three fault clearance
attempts, contact a competent
person.
Set the external controller cor-
rectly (→ Controller operating in-
structions).
15
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Easicom 3 24c and is the answer not in the manual?
Questions and answers
How does easicom 3 25r know what heating temperature is required?
The Glow-worm Easicom 3 24c determines the required heating temperature by allowing the user to set the heating flow temperature using the control buttons. The display shows the current heating flow temperature, and the user can adjust it by increasing or decreasing the selected setting. The system also considers the filling pressure in the heating installation and the operating mode, which are displayed on the basic display.
This answer is automatically generated