Setting The Heating Flow Temperature; Product Settings; Setting The Timer; Switching The Product To Standby Mode - Glow-worm Easicom 3 24c Operating Instructions Manual

4.7 Setting the heating flow
temperature
Conditions: Temperature controlled by the boiler,
with heating mode activated
▶
Set the heating flow temperature on the
boiler (→ Page 11).
Note
The competent person may
have adjusted the maximum
possible temperature.
Conditions: Temperature controlled by the control-
ler, with heating mode activated
▶
Set the maximum heating flow temper-
ature on the boiler (→ Page 11).
▶
Set the room temperature on the con-
troller.
◁
The actual heating flow temperature
is set automatically by the controller.
Conditions: Outside temperature sensor connected
to the boiler, with heating mode activated
▶
When you press the
ton.
◁
The display shows the heating flow
temperature calculated by the boiler.
◁
The actual heating flow temperature
is set automatically by the boiler.

4.8 Product settings

Note
The sequence in which the avail-
able settings are shown depends
on the operating mode selected.
If the Domestic hot water + Heat-
ing operating mode is selected,
the hot water temperature must be
confirmed in order to set the flow
temperature of the heating.
0020239561_01 Easicom 3 Operating instructions
1. Press the
2. Press the

4.9 Setting the timer

Applicability: Timer, Great Britain
1. Turn the minute hand (4) clockwise
2. Slide the pin for the time interval, in
, or but-
3. Slide the pin for the time interval, in
4. Set the selection switch (1) to the mid-
4.10 Switching the product to
▶
or button to set the tem-
perature.
button to confirm.
6
5
4
3
until the arrow (2) points to the current
time on the 24-hour dial (3).
which the heating mode should be
switched on, outwards (6).
which the heating mode should be
switched off, inwards (5).
position .
standby mode
Press the button for less than three
seconds.
◁
Once the requirement currently in
use has finished, the display will
show OFF and go out.
◁
The product is now in standby mode.
◁
The product's frost protection func-
tion is activated.
◁
The main power supply is not inter-
rupted. The product continues to be
supplied with power.
Operation 4
1
2
11