Immergas MAGIS COMBO 4 V2 Instructions And Recommendations page 10

Pay attention not to generate sparks as
follows:
– Do not remove the fuses while the unit
is on.
– Do not unplug the unit while it is on.
It is recommended to install the outlet
high up. Lay the cables in such a way that
they do not get tangled.
Wall mounting of the indoor unit must guarantee stable
and efficient support for the generator.
The plugs (standard supply) are only to be used to fix the indoor
unit to the wall; they only ensure adequate support if inserted cor-
rectly (according to technical standards) in walls made of solid or
semi-hollow brick or block. In the case of walls made from hollow
brick or block, partitions with limited static properties, or in any
case walls other than those indicated, a static test must be carried
out to ensure adequate mount.
This indoor unit is used to heat water to below boiling
temperature in atmospheric pressure.
10
They must be connected to a central heating system and
domestic hot water circuit suited to their performance
and capacity.
The appliance is built to also operate in
cooling mode.
If cold water production, during sum-
mer, could interfere and damage the cen-
tral heating only systems, necessary pre-
cautions must be taken to prevent that an
unintentional production of cold water
enters the heating only system.
Failure to comply with the above implies
personal responsibility and invalidates
the warranty.