Connecting The Chiller Line - Immergas MAGIS PRO Series Instructions And Recommendations

A treatment of the heating and water system water is required, in
compliance with the technical standards in force, in order to pro-
tect the system and the appliance from deposits (e.g. scale), slurry
or other hazardous deposits.
Water connections must be made in a rational way using the cou-
plings on the indoor unit template.
The manufacturer declines all liability in the event of
damage caused by the installation of an automatic filling
system.
In order to meet the system requirements established by EN 1717
in terms of pollution of drinking water, we recommend installing
the IMMERGAS anti-backflow kit to be used upstream of the cold
water inlet connection of the indoor unit. We also recommend
using category 2 heat transfer fluid (ex: water + glycol) in the inter-
nal unit primary circuit (heating and/or cooling circuit), as de-
fined in standard EN 1717.
To preserve the duration of appliance efficiency features,
in the presence of water whose features can lead to the
deposit of lime scale, installation of the "polyphosphate
dispenser" kit is recommended .
d
1.8

CONNECTING THE CHILLER LINE

As far as connecting the cooling line is concerned, all the instruc-
tions contained in the outdoor unit instructions booklet must be
followed.
Make the connections directly on the indoor unit couplings, or
use the rear outlet kit (optional).
1
c
a
1
2
1
a
a
c
1
a
b
6
13