Advertisement
Enter the 'TC Frame' submenu. Set the frame rate to the same as set in the 328XD timecode setup.
Press <ENTER> to confirm and enter the 'OutTc Tmg' menu. Set this to 'Digital' so the timecode is
output from the DA-98 with reference to the digital output rather than the analogue output. Press
<ENTER> to confirm and enter the 'OutTc Src' submenu. Set this to 'Tape (Abs)' so that the DA-98
timecode generation is referenced from the loaded DTRS cassette. Press <ENTER> to confirm and
<ESCAPE> to return to the main menu page.
Enter menu #7 to enable or disable MTC output, as required. The following submenus should appear:
Enter the 'MTC Out' submenu and enable or disable the MTC output. If MTC is to be used, 'Fast ' and
'Stop' should also be set in this menu.
NOTE:
With a DA-98HR, 24 bit wordlength can be selected. If this is set to on, 24 bit should also
be set as the wordlength in the 328XD Tape Port Select menu (see page 4).
Soundcraft 328XD and Tascam DTRS
9 9 9 9
Advertisement
