Digital 328 v2 and Digital 328 v2 and Digital 328 v2 and Digital 328 v2 and Korg 1212 Setup Guide Korg 1212 Setup Guide Korg 1212 Setup Guide Korg 1212 Setup Guide Contents 1 1 1 1 Connecting The System...
Besides the audio connections, the 328 Wordclock Output should be connected to the 1212 Wordclock input, to enable the 1212 to synchronize to the 328 wordclock. In this configuration, the 328 is wordclock master, and the 1212 is the wordclock slave. 328 Wordclock out 1212 Wordclock In Spirit Digital 328 v2...
Digital 328 Setup Digital 328 Setup Digital 328 Setup Digital 328 Setup Wordclock Wordclock Wordclock Wordclock To configure the Digital 328 as the wordclock master, enter the 328 Menu page by pressing the <MENU> button to the right hand side of the LCD display. Using the rotary encoder beneath the display, scroll up or down until the ‘Clock Source Sel’...
Page 5
Input > Route To: STE-1 Route To: FX-1 < SPDIF Input > < SPDIF Input > Route To: 2TRK Route To:NOWHERE If the S/PDIF input is not required, NOWHERE should be selected in the NOTE menu. Spirit Digital 328 v2...
Page 6
1212 Setup 1212 Setup 1212 Setup 1212 Setup Wordclock Wordclock Wordclock Wordclock The 1212 must be set up to receive the wordclock transmitted by the 328 (via the BNC connection). Open the Korg 1212 Utility program, accessed via the Korg ‘1212 IO’ program group on the taskbar: Korg 1212 Setup Guide...
Page 7
Now the 1212 must be configured to playback at the same samplerate as the 328. Click on the ‘Sample Rate’ pull-down menu in the ‘Word Clock & Sample Rate’ section. Here the samplerate which the 1212 plays back can be set between 44.1kHz and 48kHz: Spirit Digital 328 v2...
Page 8
This should be set to the same samplerate as the 328 was set to in the ‘Wordclock’ section in chapter 2 of this guide. If the 328 and 1212 are (wrongly) set to different samplerate settings, audio from the 1212 will playback at the incorrect speed. Saving Settings Saving Settings Saving Settings...
The desired setting can be configured via the ‘S/PDIF O/P Setup’ menu on the 328 (see the 328 manual for full instructions). Again, ensure that the relevant Korg drivers are fully installed for the software application to correctly access the 1212 S/PDIF I/O. Spirit Digital 328 v2...
Additional Information Additional Information Additional Information Additional Information If used in conjunction with an ADAT, the system should be connected as follows: Sync In ADAT ADAT ADAT ADAT Korg 1212 Korg 1212 Korg 1212 Korg 1212 ADAT I/O ADAT I/O S/PDIF I/O Wordclock ADAT Sync...