Advertisement
8 8 8 8
Soundcraft 328XD and M-Audio Lagoon
Clear all Errors
Until the Lagoon is set to synchronize to the 328XD host wordclock (page 6), the clocks will run out of
sync. Spurious clicks and pops or distorted audio may well be heard as a result. While configuring the
system then, it is likely that the Lagoon will have registered wordclock synchronization errors. To reset the
Lagoon, click on the Lagoon Tools 'Status' tab, and then the 'Clear all errors' button:
If any of the error LEDs light or remain lit, check that the ADAT connections and 328XD and Lagoon Tools
settings are correct.
NOTE:
Once the Lagoon registers no errors, the Lagoon and 328XD clocks are synchronized. The
328XD mix fader, control room and headphone output levels may be raised.
Advertisement
