Log Placement - Napoleon High Definition Series Installation And Operation Manual

finishing
EN
9.5

log placement

WARNING
!
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
appliance may not function properly and delayed ignition may occur.
• The logs are fragile and should be handled with care.
The individual logs can be easily identified by the numbers cast on the underside of each log.
Phazer logs and glowing embers exclusive to Wolf Steel Ltd., provide a unique and realistic glowing effect that is
TM
"PHAZER™ logs [and glowing embers], exclusive to Napoleon/Continental, provide a unique and realistic
different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a
During the initial use of the appliance, log colours may vary. During the initial use of the appliance the colours will
maximum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become
become more uniform as colour pigments burn in during the heat activated curing process.
more uniform as colour pigments burn in during the heat-activated curing process."
Insert only if
applicable ---->
Place the rear log (W135-
A.
0444) on rear bracket,
ensure the log is seated
properly on the rear bracket
and located on the center
pin.
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
D. Align the hole in the bottom
of the front right log (W135-
0564) with the screw and
spacer on the right side of the
burner. The bottom protrusion
should rest along the edge of
the burner and pulled forward
until it rests against the
charcoal strip.
G.
32
W415-1596 / B / 10.12.18
If applicable, insert the following statement:
note:
Log numbers are located on the bottom or back of the logs.
B. Place the charcoal strip
log (W135-0448) on
top of the grate aligning
the notches in the
charcoal strip with the
grate.
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
E. Align the holes in the
bottom of the right log
(W135-0447) with the
pins in the rear and
front right log.
Burner Overview
Align the hole in the bottom of the front log (W135-0449) with the pin
in the charcoal strip. Rest the right side of the log against the far right
grate post.
C. Align the hole in the
bottom of the front left
log (W135-0563) with the
screw and spacer on the
left side of the burner. The
middle of this log rests
against the charcoal strip.
F. Align the hole in the
bottom of the left log
(W135-0446) with the
pin in the rear log. Rest-
ing the right side of the
log against the burner.