Optional Blower Installation; Accessing The Blower - Napoleon High Definition Series Installation And Operation Manual

Table of Contents

Available languages

WARNING

• Risk of ﬁre and electrical shock!

• Turn off the gas and electrical power before servicing this appliance.

• Use only Wolf Steel approved optional accessories and replacement parts with this appliance. Using

non-listed accessories (blowers, doors, louvres, trims, gas components, venting components, etc.) could

result in a safety hazard and will void the warranty and certiﬁcation.

• Ensure that the fan's power cord is not in contact with any surface of the appliance to prevent electrical

shock or ﬁre damage. Do not run the power cord beneath the appliance.

• The wire harness provided in the blower kit is a universal harness. When installed, ensure that any excess

wire is contained, prevent it from making contact with moving or hot objects.

10.1 accessing the blower

WARNING

•

Be careful not to tear the burner train gasket. A replacement gasket can be ordered from your local authorized

dealer / distributor.

AN OPTION OR COMES STANDARD WITH THE

FRONT

GRATE

Remove the control access panel.

Remove the door, see the section "door/removal installation".

Carefully remove the log set and optional brick panels if installed, see section "log placement".

Remove the 2 screws holding the front grate in place.

Remove the 2 screws holding the rear log support.

PERIMETER SCREWS

Remove the 9 perimeter screws as illustrated and lift out the burner base assembly and gasket. (The

gas line flex-connector should provide sufficient movement to permit shifting the burner assembly on

it's side).

SPEED CONTROL

BRACKET

SPECIFIC BLOWER INSTALLATION

INSTRUCTIONS MUST BE ADDED HERE.

THIS TEMPLATE MUST BE USED WITH ANY

APPLIANCE THAT OFFERS THE BLOWER AS

APPLIANCE... AS PER THE STANDARD.

REAR LOG

SUPPORT

CONTROL ACCESS PANEL

BLOWER