Safety Signs; Product Identification Label; Main Components - Stiga LT 500 Li 48 Operator's Manual

3.2 SAFETY SIGNS

The machine has various symbols on it
(fig. 2). They are used to remind the operator
of the behaviour to follow to use it with
the necessary attention and caution.
Meaning of symbols:
WARNING! DANGER!
Failure to use this machine
correctly can be hazardous
for oneself and others
WARNING! Read the
instruction manual before
using the machine.
Anyone operating the machine
under normal conditions for
continuous daily use may
be exposed to a noise level
equal to or exceeding 85
dB (A). Use ear protection
devices and goggles.
PROJECTION HAZARD!
Be careful of flying debris
projected by the cutting
means, that can cause
serious injuries to persons
or damage to things.
PROJECTION HAZARD!
People or pets must be
kept at least 15 m away
when using the machine!
Do not leave the
machine in the rain (or
in damp conditions).
IMPORTANT Any damaged or illegible
decals must be replaced. Order replacement
decals from an Authorised Service Centre.

3.3 PRODUCT IDENTIFICATION LABEL

The product identification label
provides the following data (fig. 1 ):
1. Sound power level
2. Conformity marking
3. Year of manufacture
4. Type of machine
5. Serial number
6. Name and address of Manufacturer
7. Article code
Write the identification data of the
machine in the specific space on the
label on the back of the cover page.
IMPORTANT Quote the information on
the product identification label whenever you
contact an Authorised Service Centre.
IMPORTANT The example of the
Declaration of Conformity is provided
on the last pages of the manual.

3.4 MAIN COMPONENTS

The machine is composed of a series
of main components that have the
following functions (Fig.1 ):
A. Power unit: it drives the cutting means
through a transmission shaft.
B. Rod: it connects the rear hand
grip to the power unit.
C. Cutting means: the element
designed to cut the vegetation.
1. Cutting line head: nylon
line cutting means.
D. Cutting means guard: it is a safety
device which prevents objects drawn
up by the cutting means from being
hurled away from the machine.
E. Front hand grip: semi-circular shaped,
it is used to handle the machine.
F. Rear hand grip: used to handle the
machine and equipped with the main
on/off/acceleration control buttons.
G. Battery (if it is not supplied with the machine,
see chapter 15 "accessories on request"):
device that supplies electric current to the
tool; its specifications and regulations for
use are described in a specific manual.
H. Battery charger (if it is not supplied with
the machine, see chapter 15 "accessories
on request"): device used to recharge
the battery. Two battery charger models
are available: H1 (fast battery charge);
H2 (standard battery charge).
EN - 8