Stiga LT 500 Li 48 Operator's Manual page 34

PROBLEM
4. The line is not released
when the automatic
release is turned on
5. The cutting means
comes into contact
with a foreign body.
6. Excessive noise and/or
vibration is experienced
whilst working
7. The machine gives off
smoke whilst working
8. Battery power
reserve is low
PROBLEM
9. The battery charger
is not recharging
the battery
PROBABLE CAUSE
The line is stuck to itself
Not enough line on the
reel or reel empty
The line is worn and too short
The line is tangled on the reel or broken Remove the line from the reel
-
Loose or damaged parts.
Machine damaged
Severe working conditions
requiring greater
current absorption
Battery is insufficient for
operating requirements
Decrease in battery capacity
PROBABLE CAUSE
Battery is not correctly inserted
in the battery charger
Unsuitable environmental conditions
Dirty contacts
The battery charger is not energised
Faulty battery charger
-
Lubricate with silicone spray
Replace the reel (chap. 8.1.1)
or the line (chap. 8.1.2)
Release the line manually (chap. 6.4.2.)
and rewind it (chapter 8.1.2)
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
Do not use the machine. Immediately
turn off the machine remove the battery
and contact a service centre.
Optimise operations
(par. 7.2.1)
Use a second battery or
battery (par. 15.1)
Purchase a new battery
Check it is correctly inserted (par. 7.2.3)
Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Clean the contacts
Check it is plugged in and the
power socket is energised
Replace with an original spare part
If the problem persists, refer to the
battery/battery charger manual
EN - 17
SOLUTION
extended
SOLUTION