METHVEN TUROA Installation Manual

Wall mounted bath spout

Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with

contamination free warm soapy water and a damp soft cloth.

Periodically the stream shaper should be removed as shown below and cleaned under running water.

Methven warrants this product against manufacturing defects and that it is suitable for use

under the general operating conditions speciﬁed in this instruction sheet. However, regional

regulations apply and may aﬀect your warranty. Please refer to www.methven.com or call

customer service for full details.

New Zealand

Australia

TŪROA WALL MOUNTED BATH SPOUT

Installation Guide

Technical Speciﬁcations:

Operating Pressure:

Min: 35kPa/0.35bar

Max: 1000kPa/10bar*

Optimum: 150kPa/1.5bar - 500kPa/5bar

Operating Temperature:

Hot: Max 80°C*

Cold: Min 5°C

Inlet Connections:

All ½" BSP

* Regional speciﬁc regulations apply.

Please refer to your warranty statement at

www.methven.com

ISSUE A

www.methven.com

Table of Contents

Need help?

Do you have a question about the TUROA and is the answer not in the manual?

Page 1 Periodically the stream shaper should be removed as shown below and cleaned under running water. Methven warrants this product against manufacturing defects and that it is suitable for use under the general operating conditions speciﬁed in this instruction sheet. However, regional regulations apply and may aﬀect your warranty.
Page 2 IMPORTANT: Before you begin, turn oﬀ the water supply. General: Step 1 • Methven recommends this product is installed by a licensed plumber in compliance with all Wall lining hole should be cut or ﬁnished as • relevant regional regulations.