VERITAS 05G34.01 Quick Release

VERITAS 05G34.01 Quick Release

Front vise

Advertisement

Quick Links

Quick-Release
Front Vise
05G34.01
U.S. Des. Pat. No. D673,830

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 05G34.01 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for VERITAS 05G34.01

  • Page 1 Quick-Release Front Vise 05G34.01 U.S. Des. Pat. No. D673,830...
  • Page 2 Quick-Release Main Screw* Spring Front Plate Jaw Mounting Screws Handle End Cap Guide Rod O-Ring Quick-Release Shaft Quick-Release Lever *Main screw cover (not shown) located under main screw. ® Figure 1: The Veritas Quick-Release Front Vise mechanism, shown upside down.
  • Page 3 ® Veritas Quick-Release Front Vise Before making the jaws and installing the vise, you will • Jaw thickness: this vise was designed around a 1 " need to consider the following: thick front jaw and a 2" thick apron. A 1 "...
  • Page 4 ® Veritas Quick-Release Front Vise Positioning the Vise Mechanism Tip: When drilling the holes for the main screw, guide rods, etc., do not rotate or turn the workpiece Clamp the jaw blank to your workbench in the position on the drill-press table. (See Figure 5.) Instead, slide you want the jaw to be.
  • Page 5 ® Veritas Quick-Release Front Vise Installing the Vise Mechanism Remove the spring nut, washer and quick-release spring on the back of the mechanism. Unfasten the screw Installing the vise requires some disassembly of the holding the quick-release lever in place. Do not remove mechanism.
  • Page 6 ® Veritas Quick-Release Front Vise Four mounting holes are required to attach the vise Install the two bushings in the front mounting holes. mechanism to the underside of the workbench top. Figure 8 These are an extremely tight fi t in the base casting and shows the dimensional locations for the mounting holes may need to be driven home with a hammer.
  • Page 7 ® Veritas Quick-Release Front Vise Plane the top of the jaw so that it is fl ush with the top of the workbench. Apply the desired fi nish to the jaw. A novel feature of this vise is the quick-release half nut.
  • Page 8 " " 05G34.03 Leather Jaw Liners, pr. Figure 16: Typical rear jaw dimensions. 814 Proctor Avenue 1090 Morrison Drive Ogdensburg NY 13669-2205 Ottawa ON K2H 1C2 United States Canada customerservice@veritastools.com © Veritas Tools Inc. 2013 www.veritastools.com 843 IWE-449 Rev. B...

Table of Contents