Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for VERITAS 70G08.01
Summary of Contents for VERITAS 70G08.01
- Page 1 Front Vise 70G08.01 70G08.02...
- Page 2 The following instructions guide you through the installation vise is then a matter of spotting and boring the holes for of either the Regular Front Vise (70G08.01) or the Large the guide rods and the lead screw, and mounting the vise Front Vise (70G08.02).
- Page 3 ® Veritas Front Vise Regular Front Vise (70G08.01) Large Front Vise (70G08.02) Tools Required: Tools Required: • Drill Press • Drill Press • Hand Drill • Hand Drill • " Drill Stop • " Drill Stop • " Bit •...
- Page 4 2 " (for 70G08.02) or 1 " (for Workbench Top 70G08.01), then you should refer to Figure 3, whereby the Rear (Slab) skirt will form the rear jaw. If the skirt is not tall enough, then you have two choices.
- Page 5 A good length for increase the throat depth, a spacer may be added between the Regular Front Vise (70G08.01) is 12" to 15". For the the carriage and underside of your bench top. This will Large Front Vise (70G08.02), it may be up to 18"...
- Page 6 " saw tooth bit or an expansion bit, to a Vise Hole Dia. Hole Dia. depth of ". (Note: The Regular Front Vise (70G08.01) 70G08.01 Regular Front Vise " " does not come with support collets.) 70G08.02 Large Front Vise 1"...
- Page 7 11. Tap the front jaw so that the ends and top edge are flush with the rear jaw (or bench top if your jaw configuration If installing the Regular Front Vise (70G08.01), proceed to step 21. matches that of Figure 2). Firmly tighten the vise. Check that the carriage is in contact with the rear jaw.
- Page 8 Failure to do so may cause the tee to sit crooked, or damage either hole. 814 Proctor Avenue 1090 Morrison Drive Ogdensburg NY 13669-2205 Ottawa ON K2H 1C2 United States Canada 622, 623 customerservice@veritastools.com INS-163 Rev. D © Veritas Tools Inc. 2011 www.veritastools.com Printed in Canada.
Need help?
Do you have a question about the 70G08.01 and is the answer not in the manual?
Questions and answers