Table of Contents
Advertisement
A Guide to TracVision Cruiser
On-screen messages are not
available with DISH Network IRD
and some newer DIRECTV IRDs
(e.g., the Sony A50).
4-2
4.1.1 Satellite Signal Blocked
Satellite signals can be blocked or degraded by buildings,
other vessels, or equipment on the vessel itself. Refer to
Section 2.2, "Choosing the Best Location and Getting the Best
Reception," to make certain that the TracVision Cruiser
unit is installed in the optimal location.
4.1.2 Outside Satellite Coverage Zone
TracVision Cruiser will provide outstanding reception
throughout the entire coverage area for your satellite television
service of choice. However, signal quality can be degraded as
you approach the fringe coverage areas (e.g., off the coast of
Northern Maine). Refer to your satellite television service
manual to check the viable coverage area.
4.1.3 Radar Interference
The energy levels radiated by radar units can overload the
antenna front-end circuits. Refer to Section 2.2, "Choosing the Best
Location and Getting the Best Reception," to make certain that the
TracVision Cruiser unit is in the optimal location with regard to
your radar unit.
4.1.4 Vessel Turning During Startup
At times, an on-screen message may display ANT GYRO
ERROR (antenna gyro error) while the system has trouble
finding the satellite and tracking performance is reduced.
The most common cause of this error is the vessel turning
during the 60-second startup and initialization sequence that
occurs immediately after turning on the power to the
TracVision Cruiser unit. If the vessel is turning, the antenna
gyro records that variable motion as "standing still" which
causes the antenna to track improperly. To solve this problem,
turn TracVision Cruiser off for at least 10 seconds. Turn the
system back on, making certain that the vessel is either
motionless or travelling in a straight line for the 60 seconds
immediately following power-up.
Advertisement
Table of Contents
Troubleshooting
