Left Base Doors- Motor Adjustment - BIRO 3334FH Operating And Service Manual

AS415D
STATIONARY BAR
ASSEMBLY, SS
Item No. Description
AS415D Stationary bar assembly, SS
HHS025S Hex head screw, ¼-20 x ½ SS
LW10S Lock washer, ¼ SS
S268 Stationary bar headless screw
S119A Saw guide in stationary bar, SS
S415D Stationary bar, SS
177 Nylon filler
MOTOR ADJUSTMENT
ADJUSTMENTS
1. For tightening motor V-belt on rigid base plate, remove
appropriate quantity of shims (Part No. 324A) under the
motor until the desired total flex of the V-belt is
approximately ½".
1. For tightening motor V-belt on floating adjustable motor
mounting plates (Part No. 16015-10 or 16015-11), loosen
the upper wing nuts (Part No. 16015-3). Then loosen the
bottom wing nuts (Part No. 16015-3) which are located
under the mounting plate. This enables the motor mount-
ing plate to drop to the desired belt tension. Re-tighten
the upper wing nuts evenly so that the motor stays hori-
zontal. Do not tighten belt to extremes. This will cause
undue pressure on and premature failure of the motor
bearings.
Motor Mfg.
Doerr
Doerr
U.S. Motor
Doerr
U.S. Motor
S16217LTP
BASE DOOR
LEFT, TAPERED
PANEL, SS
24
S16217L
BASE DOOR
LEFT, SS
USE WITH
Model No.
XR72927
R72929
G54313
73020
G57016
USE WITH
Motor Mfg. Model No.
Doerr 73032
U.S. Motor G57347
Doerr 72933
Baldor L3605
Baldor L3605-50
Baldor L1322T
Doerr 67385
Baldor M3558T-5
Baldor M3558T-50
Baldor M3558T-8
Doerr 72540
Doerr 75425
U.S. Motor G57011
Baldor M3611
Baldor M3611T-50
Baldor M3611T-8
Doerr 73031
Doerr A907
27958
TO S/N
Specifications
1-1/2HP, 220/440-50/60-3 open
2HP, 220/440-50/60-3 open
2HP, 220/440-50/60-3 open
2HP, 550-60-3 open
2HP, 550-60-3 open
Specifications
1-1/2HP, 115/230-50-1 open
1-1/2HP, 115/230-50-1 open
1-1/2HP, 115/230-50-3 open
2HP, 115/230-60-1 TE
2HP, 115/230-50-1 TE
2HP, 115/230-60-1 open
2HP, 208/220/440-50/60-3 TE
2HP, 550-60-3 TE
2HP, 220/380/415-50-3 TE
2HP, 200-60-3 TE
3HP, 220/440-50/60-3 TE
3HP, 220/440-50/60-3 TE
3HP, 220/440-50/60-3 TE
3HP, 220/440-50/60-3 TE
3HP, 220/380/440-50-3 TE
3HP, 200-60-3 TE
5HP, 220/440-50/60-3 TE
5HP, 220/440-50/60-3 TE
S/N 27958 ON