Dustex 25L; 35L
8. Troubleshooting
Fault
Suction turbine does not run
Suction turbine switches off
Suction turbine does not start again after emptying container.
C-SC_CSSM
Version 1.0
2015-02-27
All rights reserved by FEIN, especially in case of industrial rights registration.
FEIN retains all rights of disposal, such as copying and circulation
Remedy
Turn the device on
Check the power cable, plug, fuse, outlet and fill level sensors
Operating mode selector switch is set to "Start/Stop Automatic".
Set the operating mode selector switch to the "Extract" symbol
and switch on the power tool connected to the socket
Check/replace device switch. Check socket
Check/replace PCB
Container is full in wet operation. Empty container
Empty container
Switch off extractor and wait 5 seconds before switching on again
Clean the fill level sensors and space between the fill level
sensors with a brush
.
Page 31 of 35