Advertisement
SWING AWAY AMPUTEE
IMPORTANT: Swing Away Amp should NOT be used during patient transfers. Weight Limit: 150 lbs
Parts Included:
1 - Swing Plate Assembly (Mount Plate, Swing Plate, Coupler)
1 - Amputee Pad
1 - Knuckle Assembly
1 - Interlock Clamp (2 Piece)
1 - 3/16" Hex Key
2 - ¼ 20 x 1½" Socket Head Cap Screw
1 - 3mm Hex Key
1
Separate the swing plate from the mount plate.
2
Using the 3/16" Hex Key, remove the two screws from the mount plate, separating the coupler
and mount plate. Place mount plate at desired position on the wheelchair and tighten coupler
around down tube of chair using the screws previously removed. (*Alternate setup: For TiLite
"Vfront" style chairs, rotate the mount plate so the post is in a rear orientation.)
3
Loosely attach the Interlock Clamp to the Amputee Pad using two ¼ 20 x 1½" screws into the
outer holes.
4
Assemble Knuckle-Swing Plate assembly to Amputee Pad using 3/16" Hex Key. For correct
assembly, make sure the toggle is on the outside of the Amputee Pad.
5
Using the 3/16" Hex Key, loosen the screw for the Swing Plate so the tube on the Knuckle
Assembly may slide in the clamping area. Tighten Knuckle Assembly into the Swing Plate
using the 3/16" Hex Key. Refer to images to ensure correct assembly for desired application.
6
Reposition Swing Plate onto Mount Plate, swing the pad towards center of chair until yellow
keeper locks into position.
7
Adjust height of the Amputee Pad so that the contact surface is at the same level as the
seating surface of the seat cushion by loosening the screw on Swing Plate. Adjust depth of the
pad by loosening the screws on the Interlock Clamp. Tighten locking screw on the swing plate
to prevent rotation.
8
To ensure that all screws are tight, securely fasten two tube clamp locking screws, mount
plate locking screw, and swing plate locking screw using 3mm Hex Key. To operate swing away
feature, press yellow keeper to unlock and swing assembly away. Once released, the swing
assembly may be removed and replaced. To lock into position, swing the pad toward the
center of chair until keeper locks into position.
AMPSAHARD
AMPSAXXYY
AMPSALGHARD
AMPSALGXXYY
Model #:
AMPSASHARD
AMPSASXXYY
1
Yellow
Keeper
Swing
Plate
Mount
Plate
3
Right-Hand
Assembly
Left-Hand
Assembly
5
Left-Hand
Assembly
2
Right-Hand
Assembly
Hanger
Left-Hand
Assembly
Coupler
Down
Mount
Tube
Plate
*
Standard Configuration
Alternate Configuration for
TiLite "Vfront" style chairs
4
Knuckle Assm.
Left-Hand
Right-Hand
Assembly
Right-Hand
Assembly
Assembly
Advertisement
