Page 1
WIKA INSTRUMENT CORPORATION Instruction Manual GAUGE PRESSURE INDICATOR Series 1500 Series 1000 Series 300 WIKA Instrument Corporation 1000 Wiegand Boulevard Lawrenceville, GA 30043 1-888-945-2872 http://www.wika.com PLEASE NOTE: THIS EQUIPMENT HAS BEEN DESIGNED TO PROVIDE RELIABLE SERVICE; HOWEVER; BEFORE ATTEMPTING TO INSTALL, OPERATE OR SERVICE THE EQUIPMENT, THIS INSTRUCTION MANUAL MUST BE READ, UNDERSTOOD AND OBSERVED.
Page 2
NOTE Minor part number changes may be incorporated into WIKA products from time to time that are not immediately reflected in the instruction book. If such a change apparently has been made in your equipment and does not appear to be reflected in your instruction book, contact your local WIKA sales office for information.
All WIKA instruments are calibrated on increasing pressure. To avoid any effect of hysteresis, take readings on increasing pressure. Instruments are calibrated at 23°C. Unless wide temperature changes are experienced, the effect of temperature may be neglected. For further discussion, see CALIBRATION CHECK.
Page 4
(see preceding paragraph) at a temperature of 23°C unless otherwise indicated. If the calibration check is conducted at 23°C, the effect of temperature on the WIKA instrument need not be considered. At any other temperature, the temperature effect listed in the table PE PERFORMANCE CAPABILITY must be considered.
GUAGE PRESSURE INDICATOR OPERATION For Precision Measurement of Gauge or SERIES 1500 BELOW 200 PSIG Compound Pressures & Vacuum SERIES 1000 BELOW 200 PSIG SERIES 300 ALL RANGES DWG 620.050.170.011 Book# 52090701 Page 5...
Page 6
GUAGE PRESSURE INDICATOR OPERATION SERIES 1500 200 PSI AND OVER SERIES 1000 200 PSI AND OVER DWG 620.050.170.021 Book# 52090701 Page 6...