Installation Planning & Layout Design - Fostoria 222 Series Manual

The Fostoria Mul-T-Mount Series offers the highest watt density and heating efficiency in an
electric infrared heater. All models are listed for spot-heat or total building heat indoors
(excluding residential), or for totally unprotected outdoor applications. Fixtures are also
listed for recessed applications, such as in ceilings or canopies.
2 and 3-Lamp models are available in either Stainless Steel , a Hi-Temp Brown Powder
Coated or an Architectural extruded aluminum housing with powder coat finish.
The specially designed "T" Tab wire channel allows for one-man installation.
No asbestos or mercury is used in the manufacture of these heaters.
CHECKING YOUR SHIPMENT
Upon receipt of your shipment, check the carton(s)
for damage.
Any accessory items ordered for heater will be
shipped in their own carton.
Claims for damaged material or shortages that
were not evident upon receipt of shipment must be
reported to carrier and Fostoria customer service
immediately.
Before starting to install the heater, make sure
that all components and accessories ordered are
available.
INSTALLER QUALIFICATIONS
Only firms or individuals qualified to perform work
in accordance with the applicable specifications for
electrical equipment should be engaged to install
Fostoria MTM systems.
inspectors, fire marshals, your local Fostoria
representative or the factory for guidance.
When positioning heaters, keep in mind the clearance to combustible materials, lights, sprinkler heads,
overhead doors, storage areas with stacked materials, gas and electrical lines, parked vehicles, cranes,
etc. Refer to page eight (8) for minimum clearance to verify that a safe installation condition exists.
ISSUE DATE 10-09-03
INSTALLATION PLANNING
Consult local building
LAYOUT DESIGN
REV. DATE 12/17
INSTALLER RESPONSIBILITY
National and local codes and ordinances together
with specifications provided by Fostoria Industries
comprise the information needed for proper
installation. The installer must furnish all materials
that have not been purchased from Fostoria
Industries or its representatives. It is the installer's
responsibility that the materials and methods of
installation result in a job that is workmanlike and
in keeping with all applicable codes.
In storage areas where stacking of materials
may occur, the installer must provide signs which
specify the maximum stacking height so as to
maintain the required clearances to combustibles.
ELECTRICAL BONDING (GROUNDING)
A protective non-corrosive conductor terminal
must be firmly attached to a protective bonding
conductor (both supplied by customer). This must
then be secured to the heater with the supplied
green screw and lock washer in the heater wire-
way to ensure a proper bond (ground).
REV. LEVEL: 17 ECO 1-7383
6
OIPM P/N 8329