Optional Wire Guard Installation Models Th And Thss - Fostoria 222 Series Manual

OPTIONAL WIRE GUARD INSTALLATION MODELS TH AND THSS

Heater Series Wire Guard
222 CHWG-222
223 CHWG-223
342 CHWG-342
343 CHWG-343
462 CHWG-462
463 CHWG-463
CAUTION: DISCONNECT POWER BEFORE
INSTALLING OR SERVICING. IF THE POWER
DISCONNECT IS OUT OF SIGHT, LOCK IT IN
THE OPEN POSITION AND TAG IT TO PREVENT
UNEXPECTED APPLICATION
FAILURE TO DO SO COULD RESULT IN FATAL
ELECTRICAL SHOCK.
Mounting holes for attaching the lamp guard are provided in
heater housing. NOTE: Mounting holes are not provided on
older models. Using the drill starts provided in the heater
housing, drill a 1/8" diameter hole at each location. (See
dimensional details.)
1. Place mounting clips provided, on the loops of the lamp
guard (see Detail A below).
2. Attach the lamp guard to the heater using the #8 sheet
metal screws provided.
MAINTENANCE
CAUTION: Disconnect power before installing or
servicing. If the power disconnect is out of sight, lock
it in the open position and tag it to prevent unexpected
application of power. Failure to do so could result in
fatal electrical shock.
To service the heater in the overhead position, it will be
necessary to remove the screws from only one side of the
lamp guard. The lamp guard will then swing clear of the
heater.
ISSUE DATE 10-09-03
Part Number
08511500
08543600
08511400
08543500
08516200
08543400
OF POWER.
Detail A
REV. DATE 12/17 REV. LEVEL: 17 ECO 1-7383
15
OIPM P/N 8329