Maintenance, Troubleshooting - Fostoria 222 Series Manual

To ensure your safety and for years of trouble-free operation of the heating system, annual service
and inspections must be done by a qualified contractor.
To obtain maximum performance from your heater(s) each year, we recommend the following be
performed at the start of the heating season:
1.Clean reflector surface with a damp cloth.
2. Clean quartz lamp with alcohol moistened soft cloth.
3. Make sure heater is secure on all hanging points.
4.Maintain the Clearance to Combustibles. Immediately remove objects in violation of the
clearance to combustibles.
If additional service to the heater is required, contact the factory or your local representative.
SYMPTOM
Element does not energize
Not enough heat.
Too much heat.
WARNING: WHEN ADJUSTING MOUNTING HEIGHT FOR MORE OR LESS HEAT, STAY WITHIN
RECOMMENDED MOUNTING HEIGHTS ON PAGE 7.
ISSUE DATE 10-09-03
MAINTENANCE
Pre-Season Maintenance and Annual Inspection
TROUBLESHOOTING
POSSIBLE CAUSE(S)
1. Defective element.
2. Improper connection.
3. Pigtail loose from socket connection.
1. Heater too small for application.
2. Heater mounted too high or too far.
1. Heater too large for application.
2. Heater mounted too low or too close.
REV. DATE 12/17
1. Replace element.
2. Check connection to power source.
3. Rewind or re-insert pigtail into socket.
1. Add more heaters.
2. Decrease mounting height or distance.
1. Replace with smaller heater.
2. Increase mounting height or distance.
REV. LEVEL: 17 ECO 1-7383
13
CORRECTIVE ACTION
OIPM P/N 8329