Continuous Output; Error Messages - KERN PLJ-GM Series Operating Instruction

9.5.3 Continuous output

The balance may be operated in a mode enabling continuous output of weighing
results. This mode can be turned on/off by commands via RS232.
Data record format:
1 2 3
S I Space Stability
indicator
Stability indicator Space if stable,
Presign: Space, if positive
Weight: 9 signs, right justified
Unit:

10 Error messages

„Err2":
„Err3":
„Err4":
„Err5":
„Err7":
„Err8":
„NULL":
„FULL2":
„LH":
„5-Full": Display range exceeded upon totalising
52
4 5 6
Space Pre
sign
? if not stable
^ if overload
v if underload
negative sign, if negative
3 signs, left justified
Value outside zero range
Value outside taring range
Calibration weight outside allowable range (+-1% for
calibration weight)
Piece weight smaller than readability
Disconnection time was too short
(should be more than 3 seconds)
Impossible to carry out taring / resetting
Underload
Weighing range exceeded
Initial weight error Weight of weighing plate outside
allowable tolerance of 10%
7-15 16 17
Weig Spac Unit
ht e
PLJ-GM-BA-e-1614
18 19 20 21
CR LF