Abtus ABT-7100 Instruction Manual page 21

21
Figure 24 Geometry recording in progress
Push the TGMD along the track and the red line of the screen which indicates the position of
the TGMD will also move along the graph. The Gauge, SE and Twist are all measured and the
instantaneous readings can be found above the graph along with the current position.
You can add events such as Signal, Crack, Bridge etc. as well as custom text events which
may happen during the recording by pressing the corresponding buttons on the right side of
the screen as shown in Figure 24. TGMD software will record the position of the event and the
type of event when such a button is pressed. Pressing the "Type in an event" button will open
a window as shown in Figure 23 where you are able to type a custom event name and add it
to the recording.
Figure 25 Geometry recording in progress
When the recording is finished, press "Finish Recording" to stop the measurement and save
the data.
ABT 7100 – Issue 02