Troubleshooting With Chassis And Interface Alarm Messages On The Srx650 Services Gateway - Juniper SRX650 Hardware Manual

Related
Documentation
Troubleshooting with Chassis and Interface Alarm Messages on the SRX650 Services
Gateway
Copyright © 2018, Juniper Networks, Inc.
Table 34: Component LEDs on the Services Gateway Chassis (continued)
LED
SRE/ACE 1.1
SRX650 Services Gateway Front Panel on page 18
SRX650 Services Gateway Back Panel on page 24
Troubleshooting with Chassis and Interface Alarm Messages on the SRX650 Services
Gateway on page 129
Troubleshooting the Power System on the SRX650 Services Gateway on page 132
Using the RESET CONFIG Button on the SRX650 Services Gateway on page 135
Changing the RESET CONFIG Button Behavior on the SRX650 Services Gateway on
page 136
When the services gateway detects an alarm condition, it lights the red or yellow alarm
LED on the front panel as appropriate. To view a more detailed description of the alarm
cause, issue the show chassis alarms
There are two classes of alarm messages:
Chassis alarms—Indicate a problem with a chassis component such as the cooling
system or power supply.
Interface alarms—Indicate a problem with a specific network interface.
Chapter 21: Troubleshooting Components
Location
Left side of the front chassis
panel
CLI command.
Usage
The SRE/ACE 1.1 LED has the
following indicator colors:
Green and steadily on indicates
ACE 1.1 half slot is functioning
normally. Not applicable with
SRE full slot module.
Amber and steadily on indicates
ACE 1.1 half slot is initializing,
performing diagnostics, or going
down. Not applicable with SRE
or ACE full slot modules.
Red and steadily on indicates
ACE 1.1 half slot failure. Not
applicable with SRE or ACE full
slot modules.
Off indicates ACE 1.1 half slot is
empty.
NOTE: ACE modules are currently
not available for ordering, but might
be supported in a future release.
129