Stahls A2Z HEAT PRESS Operator's Manual page 7

Operating Instructions
Using the swing handle, move the upper Position the garment on the lower platen,
platen to access the lower platen. While heating, centering the transfer area on the platen.
the print handle should remain raised to
extend the life of the silicone pad.
For best results, "thread" the garment around Some transfer products recommend a
the lower platen so a single layer of fabric is "pre-press" to heat and flatten the garment
on top of the silicone pad. before printing. Using the swing handle,
position the upper platen over the garment.
Lower the print handle fully until the upper platen Swing away the upper platen and align
locks into the press position. After the recommended the transfer on the garment.
pre-press time has elapsed, lift the print handle.
Lower the print handle fully until the upper platen Using the swing handle, move the upper platen
locks into the press position. After the required to access the garment. Depending on the
time has elapsed, lift the print handle. transfer, peel the carrier hot or cold.
7