Stahls Hotronix Manual

Fusion (Model XF)
Controller V4.5 & TRIAC Replacement
Fusion (Model XF)
Controller Replacement Guide
Fusion [Model XF-IQ]
2015-03-08
Adjustment Spindle Replacement
Fusion IQ ( XF/XRF/XRF2)
Adjustment Spindle
2015-10-26
Fusion (Model XF)
1
Temperature Probe Replacement
1. Required Tools: Paper Clip
5
2015-12-22
1
1
2
5
3
2. CAUTION: Turn off power and detach power cord
4
8 9
10
3. Insert the Paper Clip into the small hole on either
side of the housing
4. Press in the Paper Clip until two clicks are heard:
the first click releases the Controller bezel and the
second click ejects it from the housing as shown
Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals
Technical Assistance: 1-(800)-727-8520
Manuals: hotronix.com/heat-press-manuals
7
3
6
2
3
4
5
2
6
6
7
12
14
13
11
4
Included Parts:
5. Repeat the process on the other side of housing
Included Parts:
1. Controller
8
1. Hub Caps
2. Controller Overlay
2. Spherical Washer
3. Temperature strips
Included Parts:
3. Washer
4. Zip ties
1. Temperature Probe (P/N: 1-1272-1)
4. E-Clip
5. TRIAC
`
5. Adjustment Spindle
6. Adapter Harness (older models only)
Required Tools:
7. 9-Pin Connector (where applicable)
2. Allen Wrenches (3/32", 9/64")
7
Required Tools:
3. Needle-Nose Pliers
6. Allen Wrenches (3/32" & 9/64")
Required Tools:
4. Scissors
7. Flathead Screwdriver
8. Allen Wrenches (3/32" & 9/64")
5. #2 Phillips Screwdriver
8. Protective Eyewear (recommended)
9. #2 Phillips Screwdriver
6. 2mm Precision Flathead Screwdriver
10. #1 Phillips Screwdriver
7. Electrical Tape
6. Remove the old Controller and insert the new
15
11. 2mm Precision Flathead Screwdriver
replacement Controller
12. Scissors
13. Wire Cutters (9-pin repair only)
14. Wire Strippers (9-pin repair only)
15. Permanent Marker (9-pin repair only)
CAUTION: Detach power cord before
CAUTION: Detach power cord before
proceeding
proceeding
CAUTION: Detach power cord before
7. Press on the two latch points with your thumb until
proceeding
a click is heard; if the Controller bezel does not sit
flush with the housing plastic, it has not latched
Lower heater but do not lock into place, such
Lower heater but do not lock into place, such
that it rests gently on lower platen
that it rests gently on lower platen
8. Plug in and turn on heat press to verify function
1-800-727-8520 Page 1 of 1
www.hotronix.com 2018-04-26
1/8"
Page 1 of 9
Page 1 of 17
Page 1 of 9