Cisco Quad Camera Camera Manual page 8

Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents
SpeakerTrack 60 Camera
Video
• Two HDMI cables from the cameras.
Power
• Power rating: 12 V , 6.5 A.
DC
• Always use the provided cables and power adapter.
• Power out to cameras (internal connection).
Ethernet
Two Ethernet ports are used for the internal camera control con-
nection. The third connector is used for connecting the codec.
Use Ethernet cable only. Do not connect a serial VISCA
cable to the Ethernet port on the SpeakerTrack 60 camera,
as this will cause severe damage to the camera.
Microphone connectors
The right set is used for internal connection to the microphone
panel. The left set of connectors is intended for future use.
Kensington lock
The Kensington lock may be used to prevent the camera from
being moved from its place or to prevent theft.
For more information about the SpeakerTrack 60 setup, refer to
the following installation guides:
Cisco TelePresence SpeakerTrack 60 installation guide
Cisco Webex Codec Pro installation guide
Cisco TelePresence SX80 Installation Guide
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction Physical interface Physical interface Connecting to a codec
Power out to Power in Ethernet
cameras RJ45
camera control
8
Factory reset
Ethernet USB* Microphones
RJ45 on panel
codec
Additional
connectors*
During a call, the LED is lit on the camera
that is currently sending the live picture.
The status LED is continuously lit when
power is On.
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide
Appendix
Chinch
connectors*
* For future use