Connect Speakertrack 60 To Sx80 Codec - Cisco Quad Camera Camera Manual

Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents

Connect SpeakerTrack 60 to SX80 Codec

• Connect the video cables (HDMI).
Left camera: Connect between Connector 1 (HDMI input) on the
codec to the HDMI input of the left camera.
Right camera: Connect between Connector 2 (HDMI input) on the
codec to the HDMI input of the right camera.
• Connect the camera control cable (Ethernet). Connect between
the codec's 2nd or 3rd Ethernet port to the Network port
(Ethernet) on the SpeakerTrack 60 connector panel.
• Connect the power adapter to the SpeakerTrack 60 connector
panel and connect to power.
• Connect other codec cables as described in
Telepresence SX80 installation guide.
RJ45
HDMI 1
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction Physical interface
theCisco
HDMI 2
Power
(100-240 V , 50/60 Hz)
AC
Connecting to a codec Connecting to a codec
Right
Power
adapter
Always use the provided power cable
and adapter.
20
Factory reset Appendix
Left
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide