Table of Contents
Advertisement
Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents
Connecting multiple cameras to the SX80 codec
Main camera
Normally you should use Video Input Connector 1 (HDMI) on
the codec for the main camera.
SX80 Codec
...
Ethernet switch
...
Connect camera control
to the extra cameras
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction
Physical interface
Using the analog video or DVI-I inputs
You can connect a third party analog camera to the analog
video input on the codec. S-Video: Connect to both the Y
and C connectors; Composite: Connect to the Y connector.
Note that camera control is not available for this connector
(Connector 5).
Note that the DVI-I and BNC video inputs are mutu-
ally excluding, you may only use either the DVI-I, the
Composite, or the S-video at a time.
Analog video input (BNC):
•
Composite: Y
•
S-video: Y and C
Connecting to a codec
Connecting to a codec
Video switch (HDMI)
...
Connect video from
the extra cameras
28
Factory reset
Appendix
Adding multiple cameras
The SX80 codec supports up to seven cameras.
The codec has four simultanous video input con-
nectors for cameras and content.
•
For four cameras and no content, all three HDMI
inputs, and either the analog video input (BNC)
or the DVI input can be used for cameras.
•
If the total number of input sources (cameras
and content) exceeds four, you will need an
external video switch. If any of the cameras are
connected through the video switch you will
need a program (macro) to change camera IDs
in the API.
•
If you need more than two Ethernet ports for
camera control or other devices (for example a
Touch controller), then you will need an Ethernet
switch.
•
If you connect a camera to the DVI-I input, you
must add the camera's serial number to be able
to control the camera (Cameras > Camera n >
AssignedSerialNumber).
•
Only one camera with speaker track function-
ality can be connected at the time. Cameras
with speaker track functionality, are the Quad
Camera and SpeakerTrack 60.
•
Multiple PTZ-12 cameras are supported from
CE9.7.
See the
Customization Guide
for details on macros
and the use of an external video switch.
https://www.cisco.com/c/en/us/support/
collaboration-endpoints/spark-room-kit-series/
products-installation-and-configuration-guides-list.
html
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide
Hide quick links:
Advertisement
Table of Contents
