Cisco Quad Camera Camera Manual page 9

Cisco Quad Camera, Precision 60, SpeakerTrack 60 and PTZ-12 Camera
Contents
PTZ-12 Camera
Video
• HDMI is the main video source. The maximum resolution is
1080p60.
Power
• Power rating: 12 V , 1.4 A.
DC
• Always use the provided cables and power adapter (12V
JEITA type4). Do NOT use any other AC power adaptor.
Ethernet
For camera control.
Factory reset
A factory reset should only be performed by a system adminis-
trator or in contact with Cisco technical support.
For more information about the PTZ-12 setup, refer to the
 Cisco Webex Room Kit Plus PTZ-12 installation guide
Bottom view
D15296.10 Cisco Quad Camera, Precision 60, SpeakerTrack 60, and PTZ-12 Camera SEPTEMBER 2019.
Introduction Physical interface Physical interface
,
DC
Screw holes (for
camera mounting)
VISCA/LAN switch
(Switch 1: on; Switch
2-8: OFF)
Tripod (for camera
mounting)
Screw holes (for
camera mounting)
Connecting to a codec
Not in use
HDMI video Not in use
connector
9
Factory reset Appendix
Factory reset
Ethernet Power input
Camera
control
The LED is green when the
power is On. The LED is
off when the system is on
standby mode.
The LED is amber
when the camera is on
standby mode.
Copyright © 2019 Cisco Systems, Inc. All rights reserved.
Camera guide